Fujitronic Programmable Operation Display UG520H-x Manual de usuario descargar pdf (Pagina 105)

2 - 36

Macro type to specify network ••••••••••••••••••••••••••••[OUT_ENQ] command of [SYS]

The addresses n+0 and n+1 are fixed for 0 and 2.

Specify n+2 [System code] to 1: NET/10 2: NET II(/B)

Enter “0” to n+3 [Network No.] when n+2 [System code] indicates “2”, and “the number to be

accessed” to n+3 [Network No.] when n+2 [System code] indicates “1”.

No macros can include this command except Open Macro. Communication error will occur due to the

execution of the netware change when this command is used in other kinds of macros.

Refer to the “UGseries Manual <Function> (FEH376)” for further information on Macro.

Also refer to MITSUBISHI's manual for network registration.

See MITSUBISHI’s manual for details on the NET II(/B) data link system and the NET/10 network system.

Available Memory

See P2-16, “A/QnA series link units” and P2-22, “A/QnA series CPU port” for available memory of the PLC to

be accessed.

Note that CPU No. should be set on the UG00S-CW.

Wiring

See the wiring diagrams on P2-16,17, “1 MITSUBISHI PLC • 1.”

12 MITSUBISHI PLC • 6

F1 Memory

n+0 0 (fixed)

n+1 Specify network: 2 (fixed)

n+2 System code

n+3 Network No.

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 274 275

Sin comentarios

Fujitronic Programmable Operation Display UG520H-x Manual de usuario Pagina 105