Fujitronic Programmable Operation Display UG520H-x Manual de usuario descargar pdf (Pagina 262)

3 - 48

UG320HD

UG320HD Backlight Unit Replacement

(Required Tool)

Screwdriver

Do not touch cables and boards that are not associated with backlight

unit replacement. Doing so may result in failure.

When replacing the backlight, take appropriate preventive measures

against static electricity.

* The point of measures against static electricity is to keep the entire workplace including humans at

the same electric potential. Use an anti-static wristband or mat to prevent static electricity.

1. Turn the POD over, and remove the 9 external screws.

Place it on a cloth, etc. to protect the display panel from scratches.

Screws

Rear external case

2. Remove the rear external case.

Do not remove the gasket.

Connector B

Front external case

Ribbon cable

Connector C

Connector A

Connector E

Gasket

Ribbon cable

Connector D

3. Remove the connectors A to E.

Hold the connector and pull it out. Do not twist or yank on the cable

then.

* Leave position marks on the connectors B and C, A and D to check the positions when reattaching

them.

7 How to Replace the Backlight Unit

1 2 ... 257 258 259 260 261 262 263 264 265 266 267 ... 274 275

Sin comentarios

Fujitronic Programmable Operation Display UG520H-x Manual de usuario Pagina 262